Having wireless car remotes for your 2003 Honda CRV adds a layer of convenience to your daily life. Being able to lock and unlock your doors, or even activate the panic alarm from a distance, is a standard feature many drivers rely on. If you need to program new remotes or reprogram existing ones for your 2003 Honda CRV, this guide provides simple, step-by-step instructions to get you back to enjoying keyless entry. It’s important to note that initiating the programming sequence will erase all previously programmed remotes, requiring you to reprogram all of them again. Ensure you have all remotes you intend to use ready before starting this process for your 2003 Honda CRV.
Step-by-Step Guide to Program Your 2003 Honda CRV Wireless Remotes
Follow these steps carefully to program your 2003 Honda CRV wireless car remotes:
-
Turn the ignition to the ON (II) position. This is the position right before you would crank the engine to start.
-
Press the LOCK or UNLOCK button on one of your remotes. It doesn’t matter if the remote is currently programmed or not for this step.
-
Turn the ignition switch to the LOCK (0) position. This is the position where the car is off and the key can be removed (though you will not remove it yet).
-
Repeat steps 1, 2, and 3 two more times. Use the same remote and buttons as in step 2 for these repetitions. You will have cycled the ignition ON, pressed a remote button, and turned OFF a total of three times.
-
Turn the ignition switch to the ON (II) position again. This will be the final time you turn it to the ON position in this sequence.
-
Press the LOCK or UNLOCK button on the same remote used in step 2. At this point, the power door locks should cycle (lock then unlock) automatically. This confirms that your 2003 Honda CRV has successfully entered programming mode.
-
Press the LOCK or UNLOCK button on each remote you wish to program. For each remote, after pressing a button, the door locks should cycle again to confirm that the system has accepted and programmed that specific remote. Make sure to program all remotes you intend to use, including the one used in the initial steps.
-
Turn the ignition switch to the LOCK (0) position. This action will exit the programming mode.
-
Test all programmed remotes. Press the LOCK and UNLOCK buttons on each remote to ensure they are working correctly with your 2003 Honda CRV’s door locks.
By following these steps, you should be able to successfully program your 2003 Honda CRV wireless car remotes and regain the convenience of keyless entry. If you encounter any issues or need replacement remotes, visit Keylessentryremotefob.com for a wide selection of key fobs and further assistance.
